Figure 521: Displaying Detailed Entries From Ipv6 Multicast Routing Table; Configuring Pim For Ipv4 - Edge-Core ECS4620-28T Quick Start Manual

Configuring PIM for IPv4

Enabling PIM Globally

Figure 521: Displaying Detailed Entries from IPv6 Multicast Routing Table

This section describes how to configure PIM-DM and PIM-SM for IPv4.
Use the Routing Protocol > PIM > General page to enable IPv4 PIM routing globally
on the router.
Command Usage
◆
This feature enables PIM-DM and PIM-SM globally for the router. You also need
to enable PIM-DM or PIM-SM for each interface that will support multicast
routing (see page 760), and make any changes necessary to the multicast
protocol parameters.
◆
To use PIM, multicast routing must be enabled on the switch (see
Multicast Routing Globally" on page
Web Interface
To enable PIM multicast routing:
1.
Click Routing Protocol, PIM, General.
2.
Enable PIM Routing Protocol.
3.
Click Apply.
754).
– 759 –
Chapter 20
| Multicast Routing
Configuring PIM for IPv4
"Enabling