Remote Connections - Edge-Core ECS4610-24F Management Manual

Make sure the terminal emulation software is set as follows:
3.
■
■
■
■
■
■
Once you have set up the terminal correctly, the console login screen
N :
OTE
will be displayed.
For a description of how to use the CLI, see
Interface" on page
information on using the CLI, refer to
page 576.
Prior to accessing the switch's onboard agent via a network connection,
R
EMOTE
you must first configure it with a valid IP address, subnet mask, and
C
ONNECTIONS
default gateway using a console connection, or DHCP protocol.
An IPv4 address for this switch is obtained via DHCP by default. To
manually configure this address or enable dynamic address assignment via
DHCP, see
This switch supports four Telnet sessions or four SSH sessions.
N :
OTE
Any VLAN group can be assigned an IP interface address
N :
OTE
for managing the switch.
After configuring the switch's IP parameters, you can access the onboard
configuration program from anywhere within the attached network. The
onboard configuration program can be accessed using Telnet from any
computer attached to the network. The switch can also be managed by any
computer using a web browser (Internet Explorer 5.0 or above, Netscape
6.2 or above, or Mozilla Firefox 2.0.0.0 or above), or from a network
computer using SNMP network management software.
The onboard program only provides access to basic configuration functions.
To access the full range of SNMP management functions, you must use
SNMP-based network management software.
Select the appropriate serial port (COM port 1 or COM port 2).
Set the baud rate to 115200 bps.
Set the data format to 8 data bits, 1 stop bit, and no parity.
Set flow control to none.
Set the emulation mode to VT100.
When using HyperTerminal, select Terminal keys, not Windows
keys.
567. For a list of all the CLI commands and detailed
"Setting an IP Address" on page
– 69 –
| Initial Switch Configuration
C 2
HAPTER
Connecting to the Switch
"Using the Command Line
"CLI Command Groups" on
71.
(page 71)