Snsdata; Spcncrd; Spnlcrd; Storioa - IBM iSeries Series Hardware Problem Analysis And Isolation

Problem or message
Slot unavailable due to 64 bit card in adjacent slot
LED control failure, do not use slot
Power control failure, do not use slot
Multi-adapter bridge card slot error, do not use card slot
This ends the procedure.

SNSDATA

For use by authorized service providers.
This is a portion of the SCSI sense data associated with the unit reference code (URC); it is not a failing
item in and of itself. This data is referenced by certain failure isolation procedures within the All 3995
Publications and Documentation

SPCNCRD

For use by authorized service providers.
An SPCN card may be failing. Go to symbolic FRU "TWRCARD" on page 470, and replace the SPCN
card in the system unit.

SPNLCRD

For use by authorized service providers.
The control panel electronics card may be the failing item. See the SPNLCRD Symbolic FRU in the
Migrated Expansion Tower Problem Analysis, Repair and Parts

STORIOA

For use by authorized service providers.
Replace the storage I/O adapter. Use the I/O adapter location information in the Service Action Log if it is
available. If the location is not available, find the address of the I/O adapter. See SRC address formats.
Use the address to find the location. See Locations and addresses.
If the failing item is in a migration tower, go to the STORIOA symbolic FRU in the Migrated Expansion
Tower Problem Analysis, Repair and Parts manual on the V5R1 Supplemental Manuals web site
Meaning or corrective action
The card location specified in the DSA is unavailable for
the card installed there. Do not use that card location.
The card location with a multi-adapter bridge function
number 1 (one) less than the multi-adapter bridge
function number in the DSA has a 64 bit card installed.
The 64 bit card is using the 32 bit PCI bus of the card
location specified in the DSA.
To determine the multi-adapter bridge function numbers
and the card locations they specify, see the "DSA
breakdown" on page 63 in the Bus PIP overview page.
System code has detected a problem with the controls for
the Light Emitting Diode at the card location specified by
the DSA. Do not use that card location.
System code has detected a problem with the power
controls at the card location specified by the DSA. Do not
use that card location.
System code has detected a problem with the controls at
the card location specified by the DSA. Do not use that
card location.
web site.
.
Analyze hardware problems
.
463