Ptt Electrical System; Checking The Fuse; Checking The Ptt Relay - SELVA MARINE Grey Whale 200 EFI Service Manual

NOTE:
If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole when the cap is removed.
6. If the fluid is below the correct level, add
recommended fluid.
Recommended PTT fluid:
ATF Dexron II
7. Install a new O-ring and the reservoir cap
1, and then tighten the reservoir cap to
the specified torque.
NOTE:
Repeat steps 1–7 until the fluid remains at
the correct level.
Reservoir cap 1:
7 N·m (0.7 kgf·m, 5.2 ft·lb)

PTT electrical system

Checking the fuse

1. Check the fuse for continuity. Replace
the fuse if there is no continuity.
NOTE:
For the location of the fuse, see Chapter 8,
"Fuse holder."

Checking the PTT relay

1. Using the special service tool check the
PTT relay for continuity. Replace the PTT
relay if out of specification.
6AL3J11
Tilt cylinder and trim cylinder / PTT electrical system
Test harness (2 pins): 90890-06867
PTT relay continuity
Sky blue (Sb) – Terminal 4
Light green (Lg) –
Terminal 4
Terminal 1 – Terminal 4
Terminal 2 – Terminal 4
Terminal 1 – Terminal 3
Terminal 2 – Terminal 3
7
5
Lg Sb
Lg
Sb
G/W G
2 3
4
S6AL7980
Continuity
Continuity
No continuity
1
2
1
3
4
5
6
7
8
9
7-58