Assembling The Trim Ram; Installing The Tilt Cylinder; Installing The Trim Ram - SELVA MARINE Grey Whale 200 EFI Service Manual

BRKT

Assembling the trim ram

CAUTION:
Do not use a rag when assembling the
PTT unit as dust and particles on the PTT
unit components can lead to poor perfor-
mance.
1. Install a new O-ring 1, the backup ring
2, the spring 3, the adapter 4, and the
circlip 5 to the trim piston 6.
2. Install a new dust seal 7, the circlip 8,
and a new O-ring 9 to the trim cylinder
end screw 0.
3. Install the trim cylinder end screw 0 onto
the trim ram A.

Installing the tilt cylinder

CAUTION:
Do not use a rag when assembling the
PTT unit as dust and particles on the PTT
unit components can lead to poor perfor-
mance.
1. Install a new O-ring 1 to the free piston
2.
7-53
Bracket unit
2. Push the free piston 2 into the tilt cylin-
der 3 until it bottoms out.
3. Install the tilt cylinder 3 to the PTT body
4.
4. Install the pipes 5 and 6, and then
tighten the pipe joints to the specified
torque.
Pipe joint:
15 N·m (1.5 kgf·m, 11.1 ft·lb)

Installing the trim ram

CAUTION:
Do not use a rag when assembling the
PTT unit as dust and particles on the PTT
unit components can lead to poor perfor-
mance.
1. Hold the PTT body 1 in a vise using alu-
minum plates a on both sides.
6AL3J11