Checking The Fuel Filter - SELVA MARINE Grey Whale 200 EFI Service Manual

4. Install the port intake manifold, fuel rail
covers, and flywheel magnet cover.
NOTE:
To install the intake manifold, see Chapter 4,
"Installing the intake manifold."

Checking the fuel filter

1. Disconnect the water detection switch
coupler (blue) 1.
2. Remove the clamp 2 from the water
detection switch lead 3, isolator lead 4,
oil pressure sensor lead 5, and PTT
switch lead 6.
3
6
2
3. Remove the fuel filter cup assembly 7.
NOTE:
• Do not twist the water detection switch lead
3 when removing the fuel filter cup assem-
bly 7.
• Be sure not to spill any fuel when removing
the fuel filter cup assembly.
4. Check the fuel filter element 8. Replace
the fuel filter element if there is dirt or
residue.
5. Check the fuel filter cup assembly 7.
Clean with straight gasoline if there are
foreign substance or replace if cracked.
6AL3J11
1
5
4
S6AS3010
Top cowling / Fuel system
8
7
9
0
NOTE:
• When cleaning the fuel filter cup assembly,
be sure not to remove the clip 9 and float
0, otherwise the water detection switch
may be damaged.
• To check the fuel cup for leaks, see Chap-
ter 4, "Checking the fuel filter assembly."
• Check the water detection switch each time
the fuel filter is checked.
• To check the water detection switch, see
Chapter 8, "Checking the water detection
switch."
6. Install the fuel filter cup assembly 7.
NOTE:
Do not twist the water detection switch lead
3 when installing the fuel filter cup assembly
7.
7. Connect the water detection switch cou-
pler (blue) 1.
8. Fasten the water detection switch lead
3, isolator lead 4, oil pressure sensor
lead 5, and PTT switch lead 6 with the
clamp 2.
NOTE:
Be sure to leave a little slack in the water
detection switch lead.
1
2
S6AS3021
3
4
5
6
7
8
9
3-4