Installing The Wiring Harness - SELVA MARINE Grey Whale 200 EFI Service Manual

Oil filter wrench: 90890-06830
Oil filter:
18 N·m (1.8 kgf·m, 13.3 ft·lb)

Installing the wiring harness

NOTE:
• To install all of the wiring harnesses, see
Chapter 8, "Wiring harness routing."
• Perform this procedure after assembling
the power unit.
1. Fasten the cooling water hose 1, vapor
gas hoses, and check valve 2 using the
holder as shown.
1
2
8
2. Install the cooling water passage cover
and cylinder heads.
NOTE:
To install the cooling water passage cover
and cylinder heads, see Chapter 5, "Installing
the cooling water passage cover" and
"Installing the cylinder head."
3. Install the sensors and switches that
were removed to the power unit.
6AL3J11
1
2
S6AL5890
NOTE:
For the location of the sensors and switches,
see Chapter 8, "Electrical component."
4. Install the engine temperature sensor
lead 3 into the slit in the wiring harness
guide 4, and then install the wiring har-
ness guide onto the power unit.
3
NOTE:
It is recommended to check the crank posi-
tion sensor air gap before installing the wiring
harness guide to improve working efficiency.
To check the crank position sensor air gap,
see Chapter 8, "Checking the crank position
sensor air gap."
Cylinder block
1
2
4
3
3
4
S6AL5600
5
6
7
8
9
5-76