SELVA MARINE Grey Whale 200 EFI Service Manual page 133

21. Turn the crankshaft clockwise 2 full turns,
and then check that alignment marks a
through d are aligned.
d
c
a
NOTE:
After installing the timing belt, check the
valve clearances. To check the valve clear-
ance, see Chapter 5, "Checking the valve
clearance."
22. Install the cylinder head covers, and then
tighten the bolts to the specified torque in
2 stages.
1280B
1280B
1280B
6AL3J11
NOTE:
• Apply sealant to the edge of the cylinder
• Tighten the cylinder head cover bolts to the
• See the exploded diagram (5-7).
23. Install the timing belt guides 0, and then
b
S6P25725
NOTE:
If the valve clearances are adjusted or any
parts related to valve movement are replaced
after installing the timing belt, check the valve
clearances. To check the valve clearance,
see Chapter 5, "Checking the valve clear-
ance."
1280B
S6AL5380
Power unit (check and adjustment)
head cover gasket before installation.
same torque in both stages.
Cylinder head cover bolt:
1st: 8 N·m (0.8 kgf·m, 5.9 ft·lb)
2nd: 8 N·m (0.8 kgf·m, 5.9 ft·lb)
adjust the timing belt-to-timing belt guide
clearance p.
0
0
p
Timing belt-to-timing belt guide
clearance p:
1.0 ± 0.5 mm (0.04 ± 0.02 in)
1
2
3
0
4
5
6
p
7
S6AL5390
8
9
5-32