SELVA MARINE Grey Whale 200 EFI Service Manual page 111

d
11. Measure each valve clearance e and f
according to steps 12–17.
UP
IN EX
#2
#4
#6
PORT
e
f
PORT
NOTE:
Note the measurement data.
6AL3J11
c
a
b
S6P25100
EX IN
#1
#3
#5
STBD
S6P25110
e
f
STBD
S6AL5070
Power unit (check and adjustment)
Valve clearance (cold):
Intake e:
0.20 ± 0.03 mm (0.008 ± 0.001 in)
Exhaust f:
0.34 ± 0.03 mm (0.013 ± 0.001 in)
12. Measure the intake and exhaust valve
clearances for cylinder #4.
13. Turn the flywheel magnet an additional
120° clockwise and align the "2TDC"
mark g on the flywheel magnet with the
pointer b.
14. Measure the intake and exhaust valve
clearances for cylinder #5.
15. Turn the flywheel magnet an additional
120° clockwise and align the "3TDC"
mark h on the flywheel magnet with the
pointer b.
16. Measure the intake and exhaust valve
clearances for cylinder #6.
17. Similarly, measure the valve clearances
for cylinders #1, #2, and #3 in order, and
be sure to turn the flywheel magnet 120°
clockwise each time. Adjust the valve
clearances if out of specification.
1
2
3
4
5
6
7
8
9
5-10