SELVA MARINE Grey Whale 200 EFI Service Manual page 266

BRKT
2. Install a new gasket, the oil strainer 5
and bolts 6, and then tighten the bolts to
the specified torque.
Oil strainer bolt 6:
10 N·m (1.0 kgf·m, 7.4 ft·lb)
3. Install the dowels 7, a new gasket 8
and the oil pan 9, and then tighten the
oil pan bolts 0 and A temporarily.
4. Install a new gasket B, the exhaust man-
ifold C, rubber seal D, and then tighten
the exhaust manifold bolts E tempo-
rarily.
7-17
Bracket unit
5. Tighten the exhaust manifold bolts E
first, and then tighten the oil pan bolts 0
and A to the specified torques.
Exhaust manifold bolt E:
20 N·m (2.0 kgf·m, 14.8 ft·lb)
Oil pan bolt 0, A:
20 N·m (2.0 kgf·m, 14.8 ft·lb)
6. Install the dowels F, a new gasket G,
and the plate H.
7. Install the rubber seal I and cooling
water pipe J into the muffler K.
8. Install a new gasket L, the muffler K
and bolts M onto the oil pan, and then
tighten the bolts M to the specified
torque.
6AL3J11