SELVA MARINE Grey Whale 200 EFI Service Manual page 118

POWR
14. Remove the stator assembly bolts, and
then move the stator assembly.
15. Check that the " " mark e on the drive
sprocket and the " " mark f on the cyl-
inder block are aligned.
16. Check that the "II" marks c on the port
driven sprockets are aligned, and check
that the "I" marks d on the starboard
driven sprockets are aligned.
d
f
e
17. Turn the timing belt tensioner gradually
clockwise using a hexagon wrench, and
then insert a ø5.0 mm (0.2 in) pin 9 into
the hole g.
5-17
Power unit
S6AL5110
c
S6P25180
9
NOTE:
Leave the pin inserted into the hole g of the
timing belt tensioner until the timing belt is
installed again.
18. Remove the timing belt from the driven
sprockets, then from the drive sprocket.
19. Check that the " " mark e on the drive
sprocket and the " " mark f on the cyl-
inder block are aligned.
20. Check that the "II" marks c on the port
driven sprockets are aligned, and check
that the "I" marks d on the starboard
driven sprockets are aligned.
g
S6AL5A30
S6AL5340
6AL3J11