SELVA MARINE Grey Whale 200 EFI Service Manual page 283

Ram PTT motor lead
Light green (Lg)
Down
Sky blue (Sb)
13. Remove the special service tool 2.
WARNING
Make sure that the trim and tilt rams are
fully retracted when removing the special
service tool 2, otherwise fluid can spurt
out from the unit due to internal pressure.
14. Install the pipe joint at the end b, and
then tighten the pipe joints 3 to the
specified torque.
Pipe joint 3:
15 N·m (1.5 kgf·m, 11.1 ft·lb)
15. After measuring the hydraulic pressure,
connect the PTT motor leads to the bat-
tery terminals to fully extend the trim and
tilt rams.
16. Place the PTT unit in an upright position.
17. Remove the reservoir cap 4, and then
check the fluid level in the reservoir.
6AL3J11
Battery
terminal
Make sure that the trim and tilt rams are
+
fully extended when removing the reser-
voir cap, otherwise fluid can spurt out
-
from the unit due to internal pressure.
NOTE:
If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole when the cap is removed.
18. If necessary, add sufficient fluid of the
19. Install the reservoir cap 4, and then
WARNING
recommended type to the correct level.
tighten it to the specified torque.
Reservoir cap 4:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
PTT unit
1
2
3
4
5
6
7
8
9
7-34