SELVA MARINE Grey Whale 200 EFI Service Manual page 128

POWR
4. Install the camshafts with the oil seals.
PORT
E
6P2
P-IN
E
6P2
P-EX
NOTE:
• Apply molybdenum disulfide grease to the
cam lobes.
• Be sure to install the camshafts in the
proper positions.
• See the exploded diagram (5-7).
5. Check that the camshaft dowel holes are
in the position shown in the illustration.
BOW
PORT
6. Install the camshaft caps in their proper
positions as shown and with the stamped
numbers upside down.
5-27
Power unit
STBD
6P2
S-IN
6P2
M M
S-EX
M
S6AL5270
STBD
AFT
S6AL5280
PORT
7. Tighten the camshaft cap bolts to the
specified torques in 2 stages and in the
sequence shown.
PORT
4 4
3
2 2
3 3
1 1
CAUTION:
Do not reuse the bolts with seal washers
3, always replace them with new ones.
NOTE:
• Apply engine oil to the camshaft caps and
camshaft cap bolts before installation.
• Tighten the camshaft cap bolt 4 (M6 × 30
mm) to the general torque only. Do not
tighten it to 17 N·m (1.7 kgf·m, 12.5 ft·lb).
Camshaft cap bolt:
1st: 8 N·m (0.8 kgf·m, 5.9 ft·lb)
2nd: 17 N·m (1.7 kgf·m, 12.5 ft·lb)
UP STBD
S6P25E20
STBD
4
5
2
3
1
S6AL5290
6AL3J11
2
3
1
4