Checking The Cooling Water Passage Cover Anode; Installing The Cooling Water Passage Cover - SELVA MARINE Grey Whale 200 EFI Service Manual

NOTE:
To check the knock sensor, see Chapter 8,
"Checking the knock sensor."
2. Disconnect the flushing hose.
3. Remove the cooling water passage
cover bolts in the sequence shown.
4
5
9
C
0
6
1
NOTE:
See the exploded diagram (5-43).
Checking the cooling water passage
cover anode
1. Check the anodes. Clean if there are
scales, grease, or oil.
CAUTION:
Do not oil, grease, or paint the anodes,
otherwise they will be ineffective.
2. Replace the anodes
eroded.
Installing the cooling water passage
cover
1. Install the anodes 1 to the cooling water
passage cover 3.
Anode screw:
3 N·m (0.3 kgf·m, 2.2 ft·lb)
6AL3J11
3
8
B
A
7
2
S6P25860 S6P25860
if excessively
2. Install a new gasket 2 and the cooling
water passage cover 3.
3. Connect the cooling water hose 4 (cylin-
der block-to-fuel cooler) to the cylinder
block.
NOTE:
See the hose routing (4-3) and exploded dia-
gram (5-43).
4. Tighten the cooling water passage cover
bolts to the specified torque in the
sequence shown.
0
9
5
D 1
G4
8
C
Cooling water passage cover bolt:
12 N·m (1.2 kgf·m, 8.9 ft·lb)
Cylinder head
A
6
2 E
3 F
7
B
S6P25880 S6P25860
5-54
1
2
3
4
5
6
7
8
9