SELVA MARINE Grey Whale 200 EFI Service Manual page 115

1280B
1280B
1280B
NOTE:
• Apply sealant to the edge of the cylinder
head cover gasket before installation.
• Tighten the cylinder head cover bolts to the
same torque in both stages.
• See the exploded diagram (5-7).
Cylinder head cover bolt:
1st: 8 N·m (0.8 kgf·m, 5.9 ft·lb)
2nd: 8 N·m (0.8 kgf·m, 5.9 ft·lb)
19. Check the crank position sensor air gap
k.
K
NOTE:
It is recommended to check the crank posi-
tion sensor air gap before installing the wiring
harness guide to improve working efficiency.
6AL3J11
20. Install the timing belt guides 6, and then
1280B
S6AL5380
21. Install the wiring harness guide.
NOTE:
To install the wiring harness guide, see
Chapter 5, "Installing the wiring harness."
22. Install the spark plugs and ignition coils.
S6AL5100
23. Install all parts removed during disas-
Power unit (check and adjustment)
Crank position sensor air gap k:
1.4–1.6 mm (0.055–0.063 in)
Crank position sensor screw:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
adjust the timing belt-to-timing belt guide
clearance m.
6
m
6
m
Timing belt-to-timing belt guide
clearance m:
1.0 ± 0.5 mm (0.04 ± 0.02 in)
Spark plug:
25 N·m (2.5 kgf·m, 18.4 ft·lb)
Ignition coil bolt:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
sembly.
1
2
6
3
4
5
6
S6AL5090
7
8
9
5-14