Installing The Oil Pump - SELVA MARINE Grey Whale 200 EFI Service Manual

POWR

Installing the oil pump

1. Install the oil pump 1 by aligning the oil
pump gear with the crankshaft.
1
E
CAUTION:
Before installing the oil pump, be sure to
fill it with engine oil through the oil pas-
sage a.
NOTE:
When installing the oil pump, install it so that
the oil seal does not get damaged.
2. Install a new gasket and the oil filter
bracket, and then tighten the bolts in the
sequence shown.
5-75
Power unit
S6AL5510
STBD
!
$
#
NOTE:
Apply engine oil to the oil filter bracket bolts
before installation.
3. Supply engine oil to the oil passage b of
the oil filter bracket.
4. Install the oil filter, and then tighten it to
the specified torque using a 72.5 mm
(2.9 in) oil filter wrench.
NOTE:
Apply a thin coat of engine oil to the O-ring of
a new oil filter before installation.
UP PORT
%
±
E
S6AL5870
6AL3J11