SELVA MARINE Grey Whale 200 EFI Service Manual page 181

B
A
C 9
8. Connect the cooling water pilot hose F.
9. Connect the neutral switch coupler (blue)
G and shift cut switch coupler H, and
then install them onto the bracket.
10. Install the dipstick guide I and oil dip-
stick J.
J
H
STBD
NOTE:
Apply engine oil to the O-ring before installing
the dipstick guide.
11. Connect the vapor gas hose K to the
starboard top cowling lock.
6AL3J11
0
D
E
S6AL5550
I
G
F
S6AL5560
STBD
12. Connect the PTT motor leads L (blue)
and M (light green), and then fasten
them.
13. Route the positive battery cable N and
negative battery cable O along the bot-
tom of the bottom cowling a, and then
connect them.
L
a
STBD
NOTE:
To wire the PTT motor leads and battery
cables, see Chapter 8, "Wiring harness rout-
ing."
PTT motor lead bolt:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
Positive battery cable bolt:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
Negative battery cable nut:
13 N·m (1.3 kgf·m, 9.6 ft·lb)
14. Connect the fuel hose.
Cylinder block
K
S6AL5570
M
O
N
S6AL5580
5-80
1
2
3
4
5
6
7
8
9