SELVA MARINE Grey Whale 200 EFI Service Manual page 369

6. ECM record data graph: When a malfunction occurs in the electronic throttle valve system, 4
seconds (2 seconds before and after the malfunction) of recorded data are saved in the ECM.
This data can be displayed on a graph using the "ECM record data graph" of the Data logger
function.
When the communication cable is used to connect a computer to the ECM, the ECM record
data can be saved and viewed on the computer.
The saved ECM record data can also be viewed offline.
Items: For F(L)200C, F(L)225B
1 Engine speed
2 Accel position sensor
(*1)
1
3 Accel position sensor
(*2)
2
4 Throttle position sensor
1
5 Throttle position sensor 2 12 Engine stop mode
6 Intake pressure
7 Battery voltage
(*1)
: Accelerator position sensor 1
(*2)
: Accelerator position sensor 2
(*3)
: Intake air pressure
(*4)
: Target TPS voltage
This item shows the target output voltage of the TPS.
This value is the control voltage that the ECM requires to set the target opening angle of the throttle
valve.
(*5)
: Reference TPS voltage
This item shows the criterion output voltage of the TPS.
This value is used to detect the TPS output voltage during engine operation.
(*6)
: Reference accelerator position sensor voltage
This item shows the criterion output voltage of the accelerator position sensor.
This value is used to detect the accelerator position sensor output voltage when the remote control
throttle lever is opened.
(*7)
: Target TPS voltage for Idle Speed Control
ECM controls the engine idle speed by using the throttle valve attached to the TPS.
This target voltage is used by the ECM to achieve the target opening angle of the throttle valve at
the engine idle speed.
(*8)
: Engine stop mode with switch
(*9)
: Main relay (ignition coil, fuel injector, variable camshaft timing, ECM, low-pressure fuel pump, high-
pressure fuel pump)
(*10)
: Electronic throttle valve relay
(*11)
: Low engine oil pressure
NOTE:
To display the displays and graphs, see the YDIS (Ver. 1.23a or later) Instruction Manual.
6AL3J11
8 Target TPS voltage
9 Ref. TPS voltage
10 Ref. acc. pos. sensor
voltage
11 Target TPS voltage for
(*7)
ISC
(*3)
13 Engine start mode
14 Engine stop mode with
(*8)
SW
(*4)
15 Engine stop lanyard
(*5)
16 Main relay
17 Electronic throttle
(*6)
18 Overheat warning
19 Low oil pressure
YDIS
switch
(*9)
(*10)
relay
(*11)
9-4
1
2
3
4
5
6
7
8
9