Installing The Propeller Shaft Housing - SELVA MARINE Grey Whale 200 EFI Service Manual

LOWR
2. Install the washer, spring, thrust bearing
1, drive shaft, thrust bearing 2, and
original shim(s) 3 into the lower case.
3. Install the pinion, washer, and pinion nut
temporarily.
NOTE:
• Be sure to select the pinion shim(s) if
replacing the thrust bearing 2, drive shaft
housing, drive shaft, or lower case.
• To select the shims, see Chapter 6, "Shim-
ming (regular rotation model)."
• To install the pinion nut, push down on the
drive shaft.
4. Install a new O-ring to the drive shaft
housing, and then install the drive shaft
housing into the lower case.
NOTE:
Install the drive shaft housing with the cutout
a in the housing facing forward as shown.
6-17
Lower unit
5. Tighten the pinion nut to the specified
torque.
Drive shaft holder 6 4: 90890-06520
Pinion nut holder 5: 90890-06715
Pinion nut:
142 N·m (14.2 kgf·m, 104.7 ft·lb)

Installing the propeller shaft housing

1. Set the shift rod joint and dog clutch 1 to
the neutral position as shown.
2. Install the propeller shaft shim 2 and
propeller shaft assembly 3 into the pro-
peller shaft housing assembly.
3. Apply grease to new O-rings and propel-
ler shaft housing.
4
5
S6AL6150
6AL3J11