SELVA MARINE Grey Whale 200 EFI Service Manual page 341

F
b
NOTE:
Do not start the engine when checking the
accelerator position sensor.
Accelerator position sensor output
voltage
Remote control lever position
Item
Fully closed a
Sensor 1 0.550–0.850 V
Sensor 2 0.400–1.000 V
4. Operate the remote control lever, and
check that the output voltages of acceler-
ator position sensor 1 and accelerator
position sensor 2 change continuously.
5. Turn the engine start switch to "OFF."
6. Disconnect the throttle cable joint from
the accelerator position sensor.
7. Disconnect the accelerator position sen-
sor coupler.
8. Operate the accelerator lever, and mea-
sure the resistance of the accelerator
position sensor at the fully closed posi-
tion c and fully open position d.
6AL3J11
ECM and electronic throttle valve control system
N
R
a
S6AL8150
Fully open b
Above 3.250 V
(reference data)
3 4
È É
7
c
È: Fully closed position
É: Fully open position
NOTE:
When the accelerator lever is in the fully
open position d, make sure that it is contact-
ing the stopper 7 when measuring the sen-
sor resistance.
Accelerator position sensor
resistance at 20 °C (68 °F)
(reference data):
Accelerator lever position
Terminal
Fully closed c
3–4
0.800 kΩ
5–6
9. Connect the accelerator position sensor
coupler.
10. Connect the throttle cable joint to the
accelerator position sensor.
56
d
7
S6AL8160
Fully open d
5.300 kΩ
8-30
1
2
3
4
5
6
7
8
9