Adjusting The Trim Sensor - SELVA MARINE Grey Whale 200 EFI Service Manual

Adjusting the trim sensor

1. Fully tilt the outboard motor down.
2. Measure the trim sensor resistance, and
note the measurement data.
Trim sensor setting resistance:
Pink (P) – Black (B)
10 ± 1 Ω
3. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
6AL3J11
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the PTT unit should lose
fluid pressure.
4. Loosen the trim sensor screws 2.
5. Adjust the position of the trim sensor,
and then tighten the trim sensor screws
2 temporarily.
B P
S6AL7C10
NOTE:
• To decrease the resistance, turn the trim
sensor in direction a.
• To increase the resistance, turn the trim
sensor in direction b.
6. Fully tilt the outboard motor down.
7. Measure the trim sensor resistance.
Repeat steps 3–6 if out of specification.
Clamp bracket and swivel bracket
Trim sensor setting resistance:
Pink (P) – Black (B)
10 ± 1 Ω
1
2
3
4
5
6
7
8
9
7-28