Removing The Water Pump And Shift Rod; Checking The Water Pump And Shift Rod - SELVA MARINE Grey Whale 200 EFI Service Manual

LOWR
Removing the water pump and shift
rod
1. Remove the water pump housing 1 and
impeller 2.
2. Remove the Woodruff key 3.
3. Remove the outer plate cartridge 4 and
water pipe 5.
4. Set the gear shift to the neutral position,
and then remove the shift rod assembly
6.
6
Shift rod push arm: 90890-06052
Checking the water pump and shift
rod
1. Check the water pump housing. Replace
if there is deformation.
NOTE:
If the engine overheated, the inside of the
water pump housing may be deformed, so be
sure to remove the insert cartridge when
checking the housing.
2. Check the impeller, insert cartridge, and
outer plate cartridge. Replace if cracked
or worn.
6-5
Lower unit
5
3. Check the water pipe. Replace if corro-
sion, deformation or cracked.
4. Check the Woodruff key and the groove
on the drive shaft. Replace if worn.
5. Check the shift rod. Replace if cracked or
worn.
6AL3J11