Checking The Starter Motor - SELVA MARINE Grey Whale 200 EFI Service Manual

– +
ELEC
8. Remove the E-clip D, and then remove
the clutch assembly E from the pinion
shaft F.
c
D
b
a
F
E
NOTE:
Push the clutch assembly E completely
down onto the pinion shaft F in direction a,
rotate it 1 spline in direction b, and then
remove it in direction c.

Checking the starter motor

1. Check the commutator. Clean with 600–
grit sandpaper and compressed air if
dirty.
8-47
Electrical system
E
E
c
F
b
a
S6AL8240
F
S6AL8250
2. Measure the
Replace the armature if below specifica-
tion.
Commutator standard diameter:
29.0 mm (1.14 in)
Wear limit: 28.0 mm (1.10 in)
3. Measure the commutator undercut a.
Replace the armature if below specifica-
tion.
Commutator standard undercut a:
0.8 mm (0.03 in)
Wear limit: 0.2 mm (0.01 in)
4. Check the armature
Replace the armature if out of specifica-
tions.
commutator diameter.
for continuity.
6AL3J11