Bracket Unit; Checking The Ptt Operation; Checking The Ptt Fluid Level - SELVA MARINE Grey Whale 200 EFI Service Manual

CHK
ADJ
5. Align the alignment mark a on the bush-
ing and alignment mark b on the
bracket.
6. Adjust the position of the shift cable joint
until its hole is aligned with the set pin.
c
WARNING
The shift cable joint must be screwed in a
minimum of 8.0 mm (0.31 in) c.
7. Connect the cable joint, install the clip,
and then tighten the locknut.
8. Check the gear shift for smooth operation,
check the operation of the neutral switch
and, if necessary, repeat steps 3–7.

Bracket unit

Checking the PTT operation

1. Fully tilt the outboard motor up and down
a few times and check the entire trim and
tilt range for smooth operation. Check the
PTT fluid level if necessary.
3-13
Periodic check and adjustment
S6AL3120
NOTE:
Be sure to listen to the winding sound of the
PTT motor for smooth operation.
2. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1 to
check the lock mechanism of the lever.

Checking the PTT fluid level

1. Fully tilt the outboard motor up, and then
3
support it with the tilt stop lever 1.
S6P23190
6AL3J11