Disassembling The Cylinder Block - SELVA MARINE Grey Whale 200 EFI Service Manual

POWR

Disassembling the cylinder block

1. Remove the oil filter using a 72.5 mm
(2.9 in) oil filter wrench.
Oil filter wrench: 90890-06830
2. Remove the oil filter bracket bolts in the
sequence shown.
STBD
%
±
#
3. Remove the oil pump.
NOTE:
See the exploded diagram (5-59).
4. Remove the crankcase cover bolts in the
sequence shown.
UP
3
9
C
STBD
G
D
0
4 5
5. Remove the connecting rod cap bolts
and the connecting rod caps, and then
remove the connecting rod and piston
assemblies.
NOTE:
See the exploded diagram (5-57).
5-61
Power unit
UP PORT
!
$
S6P25930
2 1
8
B
PORT
F
E
A
6 7
S6P25940
6. Remove the clips 1 and piston pin, and
then remove the piston.
NOTE:
• See the exploded diagram (5-57).
• Be sure to keep the bearings in the order as
they were removed.
• Mark each piston with an identification
number a of the corresponding cylinder.
• Mark each connecting rod and connecting
rod cap on the side facing up (flywheel
magnet side) with an identification mark b.
• Do not mix the connecting rods and con-
necting rod caps. Keep them organized in
their proper groups.
7. Remove the piston rings and arrange
them in order.
8. Remove the crankcase bolts in the
sequence shown.
1
OG
5
SK
9
STBD
C PH
LD
0
2
6
9. Remove the crankshaft and bearings.
UP
4
FN
8
J R
B PORT
I Q
EM
A
3
7
S6P25960J
6AL3J11