Installing The Propeller Shaft Housing - SELVA MARINE Grey Whale 200 EFI Service Manual

NOTE:
• Be sure to select the pinion shim(s) if
replacing the thrust bearing 2, drive shaft
housing, drive shaft, or lower case.
• To select the shims, see Chapter 6, "Shim-
ming (counter rotation model)."
• To install the pinion nut, push down on the
drive shaft.
4. Install a new O-ring to the drive shaft
housing, and then install the drive shaft
housing into the lower case.
NOTE:
Install the drive shaft housing with the cutout
a in the housing facing forward as shown.
5. Tighten the pinion nut to the specified
torque.
Drive shaft holder 6 4: 90890-06520
Pinion nut holder 5: 90890-06715
Pinion nut:
142 N·m (14.2 kgf·m, 104.7 ft·lb)
6AL3J11
Drive shaft and lower case (counter rotation model)
4
5
S6AL6150

Installing the propeller shaft housing

1. Set the shift rod joint and dog clutch 1 to
the neutral position as shown.
2. Apply grease to new O-rings and propel-
ler shaft housing.
3. Install a new dowel 2 and the propeller
shaft housing assembly 3 into the lower
case.
R N F
1
4. Install the washer and propeller shaft
housing bolts 4, and then tighten the
bolts to the specified torque.
5. Install the ring 5 and bolts 6.
Propeller shaft housing bolt 4:
30 N·m (3.0 kgf·m, 22.1 ft·lb)
6. Install the water pipe and rubber seals.
1
2
3
3
4
D
2
5
S6AL6510
6
7
8
9
6-48