Checking The Shift Cut Switch - SELVA MARINE Grey Whale 200 EFI Service Manual

– +
ELEC
6. Check the switch for continuity at the
specified temperatures. Replace if out of
specification.
a Temperature
b Time
c No continuity
d Continuity
Thermoswitch continuity
temperature:
Pink (P) – Black (B)
e: 84–90 °C (183–194 °F)
f: 68–82 °C (154–180 °F)
7. Install the thermoswitches, and then con-
nect the thermoswitch connectors.

Checking the shift cut switch

1. Disconnect the shift cut switch coupler
(black).
2. Connect the test harness (2 pins) 1 to
the shift cut switch coupler (wire harness
end).
Test harness (2 pins) 1:
90890-06867
3. Turn the engine start switch to "ON," and
then measure the input voltage at the
shift cut switch coupler (wiring harness
end). Check the wiring harness if out of
specification.
8-23
Electrical system
G/W
B L/Y
1
G
G/W
B L/Y
Shift cut switch input voltage
(reference data):
Blue/yellow (L/Y) – Black (B)
4.75–5.25 V
4. Turn the engine start switch to "OFF."
5. Disconnect the test harness (2 pins) 1
from the shift cut switch coupler (wiring
harness end) and connect it to the shift
cut switch coupler (shift cut switch end).
6. To check the shift cut switch, measure
the shift cut switch resistance at position
a. Replace if out of specification.
B L/Y
G
R
N
F
S6AL8380
6AL3J11