SELVA MARINE Grey Whale 200 EFI Service Manual page 204

LOWR
2. Install a new gasket 2, the outer plate
cartridge 3, and dowels 4.
3. Install the Woodruff key 6 into the drive
shaft.
4. Align the groove on the impeller 5 with
the Woodruff key 6, and then install the
impeller onto the drive shaft.
5. Install a new O-ring 7 and the insert car-
tridge 8 into the pump housing 9.
7
9
b
6-19
Lower unit
A A
8
a
a
b
S6AL6A30
1104J
NOTE:
Align the insert cartridge projections a with
the holes b in the pump housing.
6. Install a new O-ring 0 and the pump
housing assembly A into the lower case,
tighten the bolts B, and then install the
seal C and cover D.
CAUTION:
Do not turn the drive shaft counterclock-
wise, otherwise the water pump impeller
may be damaged.
NOTE:
• When installing the pump housing, apply
grease to the inside of the insert cartridge,
and then turn the drive shaft clockwise
while pushing down the pump housing.
• Align the cover projection c with the hole
d in the pump housing.
6AL3J11