SELVA MARINE Grey Whale 200 EFI Service Manual page 225

NOTE:
• Be sure to select the propeller shaft shim(s)
if replacing the propeller shaft, propeller
shaft housing, thrust bearing or taper roller
bearing.
• To select the shims, see Chapter 6, "Shim-
ming (counter rotation model)."
4. Install a new taper roller bearing 7 and
the bearing outer race 8 into the propel-
ler shaft housing using a press.
NOTE:
After installing the taper roller bearing and
bearing outer race, check that the propeller
shaft rotates smoothly.
Ring nut wrench 9: 90890-06578
5. Install the propeller shaft housing assem-
bly in the reverse direction into the lower
case.
6AL3J11
Propeller shaft housing (counter rotation model)
NOTE:
To prevent damage to the parts when install-
ing the propeller shaft housing assembly in
the reverse direction, use flangeless bolts 0
(M8 × 30 mm) without washers.
6. Install the claw washer A and ring nut
B, and then tighten the ring nut to the
specified torque.
Ring nut wrench 9: 90890-06578
Ring nut B:
108 N·m (10.8 kgf·m, 79.7 ft·lb)
1
2
3
4
S6AL6370
5
6
7
8
9
6-40