POWR
Removing the exhaust cover
1. Remove the exhaust cover bolts in the
sequences shown.
Checking the exhaust cover anode
1. Check the anodes. Clean if there are
scales, grease, or oil.
CAUTION:
Do not oil, grease, or paint the anodes,
otherwise they will be ineffective.
2. Replace
the
anodes
eroded.
Installing the exhaust cover
1. Install the anodes to the exhaust covers.
2. Install new gaskets and the exhaust cov-
ers, and then tighten the bolts to the
specified torques in 2 stages and in the
sequence shown.
5-53
Power unit
if
excessively
NOTE:
Apply engine oil to the exhaust cover bolts
before installation.
Anode screw 1:
3 N·m (0.3 kgf·m, 2.2 ft·lb)
Exhaust cover bolt:
1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)
2nd: 12 N·m (1.2 kgf·m, 8.9 ft·lb)
Removing the cooling water passage
cover
1. Remove the knock sensor.
6AL3J11