SELVA MARINE Grey Whale 200 EFI Service Manual page 236

LOWR
3. Install the dowels 1 into the lower unit.
4. Install the lower unit into the upper case,
and then tighten the lower case mounting
bolts 2 to the specified torque.
5. Install the trim tab 3 to its original posi-
tion, and then tighten the bolt 4 to the
specified torque.
Lower case mounting bolt 2:
47 N·m (4.7 kgf·m, 34.7 ft·lb)
Trim tab bolt 4:
42 N·m (4.2 kgf·m, 31.0 ft·lb)
6. Install the propeller and propeller nut,
and then tighten the nut temporarily.
Place a block of wood between the anti-
cavitation plate and propeller to keep the
propeller from turning, and then tighten
the nut to the specified torque.
6-51
Lower unit
WARNING
• Do not hold the propeller with your
hands when loosening or tightening it.
• Be sure to disconnect the battery cables
from the battery and the clip from the
engine stop lanyard switch.
• Put a block of wood between the anti-
cavitation plate and propeller to keep
the propeller from turning.
NOTE:
If the grooves in the propeller nut 5 do not
align with the cotter pin hole, tighten the nut
until they are aligned.
Propeller nut 5:
54 N·m (5.4 kgf·m, 39.8 ft·lb)
6AL3J11