Checking The Propeller Shaft Housing - SELVA MARINE Grey Whale 200 EFI Service Manual

NOTE:
To prevent damage to the parts when install-
ing the propeller shaft housing assembly in
the reverse direction, use flangeless bolts 6
(M8 × 30 mm) without washers.
5. Remove the ring nut 7 and claw washer
8.
Ring nut wrench 9: 90890-06578
6. Remove the bearing outer race 0, taper
roller bearing A, thrust bearing B, and
propeller shaft shim(s) C using a press.
6AL3J11
Propeller shaft housing (counter rotation model)
S6AL6370 CAUTION:
• Do not press the propeller shaft threads
a directly.
• Do not reuse the taper roller bearing,
always replace it with a new one.
7. Remove the oil seals and needle bear-
ing.

Checking the propeller shaft housing

1. Check the water pipe. Replace the water
pipe if corrosion, deformation or cracked.
2. Clean the propeller shaft housing, and
then check it. Replace the propeller shaft
housing if cracked or damaged.
Needle bearing attachment D:
90890-06611
Driver rod L3 E: 90890-06652
1
2
3
4
5
6
7
8
9
6-38