Checking The Propeller Shaft; Assembling The Propeller Shaft Housing - SELVA MARINE Grey Whale 200 EFI Service Manual

LOWR
3. Check the teeth and dogs of the forward
gear. Replace the forward gear if cracked
or worn.
4. Check the bearings. Replace the bear-
ings if pitted or if there is rumbling.

Checking the propeller shaft

1. Check the propeller shaft. Replace the
propeller shaft if bent or worn.
2. Measure the propeller shaft runout.
Replace the propeller shaft if above
specification.
Propeller shaft runout limit:
0.02 mm (0.0008 in)
3. Check the dog clutch, shift rod joint, and
slider. Replace the dog clutch, shift rod
joint, or slider if cracked or worn.
Assembling the propeller shaft
housing
1. Install the needle bearing into the propel-
ler shaft housing to the specified depth.
6-39
Lower unit
S6P26220C
NOTE:
• Install the needle bearing with the manufac-
ture identification mark a facing toward the
oil seal (propeller side).
• When using the driver rod, do not strike the
special service tool in a manner that will
force the stopper c out of place.
Driver rod SS 1: 90890-06604
Needle bearing attachment 2:
90890-06610
Bearing depth plate 3: 90890-06603
Depth b:
25.3 ± 0.25 mm (1.00 ± 0.01 in)
2. Apply grease to new oil seals, and then
install them into the propeller shaft hous-
ing to the specified depth.
NOTE:
Install an oil seal halfway into the propeller
shaft housing, and then install the other oil
seal.
Bearing inner race attachment 4:
90890-06640
Depth d:
5.0 ± 0.25 mm (0.20 ± 0.01 in)
3. Install the original shim(s) 5 and thrust
bearing 6 with the propeller shaft into
the propeller shaft housing.
6AL3J11