SELVA MARINE Grey Whale 200 EFI Service Manual page 294

BRKT
4. Install the balls 0, manual release spring
A, and bracket B by installing the bolts
C, and tightening them to the specified
torque.
Gear pump bracket bolt C:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
5. Install the relief valve seal D and ball E
into gear housing 1 9, and then install
the up-relief lock screw F and down-
relief lock screw G as shown.
G
b
7-45
Bracket unit
F
a
S6AL7770
NOTE:
• If reinstalling the removed parts, install
them according to the screw height a and
screw depth b measurements noted
before they were removed.
• If installing new parts, install them accord-
ing to the following reference data for the
screw height a and screw depth b.
Up-relief lock screw height a
(reference data):
From the top of the gear housing:
1.07–1.27 mm (0.042–0.050 in)
Down-relief lock screw depth b
(reference data):
From the top of the gear housing:
1.95–2.45 mm (0.077–0.096 in)
6. Install the filters H and I and gear
pump J by installing the bolts K and
tightening them to the specified torque.
7. Install the manual valve L.
Gear pump bolt K:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
6AL3J11