Installing The Reservoir; Installing The Tilt Ram - SELVA MARINE Grey Whale 200 EFI Service Manual

BRKT
3. Remove all of the air bubbles with a
syringe or suitable tool.
NOTE:
Turn the joint 1 with a screwdriver, and then
remove any air between the pump gear teeth.
4. Install a new O-ring 2 and the PTT
motor 3, and then tighten the bolts 4 to
the specified torque.
NOTE:
Align the armature shaft with the recess in
the joint.
PTT motor mounting bolt 4:
19 N·m (1.9 kgf·m, 14.0 ft·lb)

Installing the reservoir

CAUTION:
Do not use a rag when assembling the
PTT unit as dust and particles on the PTT
unit components can lead to poor perfor-
mance.
1. Install the spacer 1, filter 2 and sheet
3 to the PTT body.
2. Install a new O-ring 4 and the reservoir
5, and then tighten the bolts 6 to the
specified torque.
7-55
Bracket unit
3. Install a new O-ring and the reservoir cap
7, and then tighten the reservoir cap to
the specified torque.
Reservoir mounting bolt 6:
19 N·m (1.9 kgf·m, 14.0 ft·lb)
Reservoir cap 7:
7 N·m (0.7 kgf·m, 5.2 ft·lb)

Installing the tilt ram

CAUTION:
Do not use a rag when assembling the
PTT unit as dust and particles on the PTT
unit components can lead to poor perfor-
mance.
1. Place the tilt cylinder end screw at the
position a (bottom of the tilt ram).
2. Fill the tilt cylinder with the recommended
fluid to the correct level b as shown.
Recommended PTT fluid:
ATF Dexron II
3. Add a small amount of the recommended
fluid through the PTT body hole c as
shown.
6AL3J11