Adjusting The Trim Sensor - SELVA MARINE Blue Whale 250 EFI Service Manual

3. Install the upper end of the tilt ram into
the swivel bracket with the shaft 4 and
circlip 5.
4. Tighten the self-locking nut 6 of the
through tube to the specified torque.
5. Install the anode 7.
6. Install the PTT motor lead to the holder
8.
7. Pass the PTT motor lead and trim sensor
lead through the hole of the starboard
clamp bracket.
8. Fasten the PTT motor lead and trim sen-
sor lead with the plastic ties 9 and then
install the holder 0.
Self-locking nut 6:
22 N·m (2.2 kgf·m, 16.2 ft·lb)
9. Inject grease into all grease nipples until
grease comes out from the bushings a.
6P23H11
Clamp bracket and swivel bracket

Adjusting the trim sensor

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the PTT unit should lose
fluid pressure.
1
2
3
4
5
6
7
8
9
7-20