Oil Applying Assembly/Removing Assembly; Removing The Oil Applying Felt - Canon 1130 Service Manual

C. Oil Applying Assembly/
Removing Assembly
The oil applying unit is ad-
justed and assembled at the
factory. Do not remove it.
Especially, do not remove
the screws [1] shown in the
figure.
If you have replaced the oil
felt, execute
COPIER>FUNCTION>
FIXING>PUMP-ON in
service mode, and press
the Stop key in about 10
min so as to impregnate
the felt with fixing oil.

1. Removing the Oil Applying Felt

1) Open the front cover.
2) Remove the fixing cover.
3) Slide out the transfer frame.
4) Remove the fixing upper cover.
5) Open the fixing upper roll unit.
6) Shift the oil applying felt shaft [1] to the
left, and remove the oil felt [2].
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 8 FIXING SYSTEM
[1]
Figure 8-432 (rear)
Figure 8-433 (front)
[1] [2]
(rear)
Figure 8-434
[1]
[1]
(front)
8-25