Disassembly/Assembly (Pick-Up Assembly) - Canon 1130 Service Manual

CHAPTER 7 PICK-UP / FEEDING SYSTEM
VII. DISASSEMBLY/ASSEMBLY (PICK-UP
ASSEMBLY)
The copier possesses the mechanical characteristics discussed in the following pages; go
through the instructions given when disassembling/assembling the copier's parts while keeping
the following in mind:
1. Disconnect the power plug before disassembly/assembly work.
2. Assemble the parts by reversing the steps used to disassemble them, unless otherwise noted.
3. Identify the screws by type (length, diameter) and location.
4. Do not leave out the toothed washer that comes with one of the mounting screws on the rear
cover to protect against static electricity.
5. Do not leave out the washer that comes with the screw used for the grounding wire and the
varistor to ensure electrical continuity.
6. Do not operate the machine with any of its parts removed, unless otherwise mentioned.
7. Keep in mind that the laser shutter is designed to close in response to the left
(i.e., when it turns off as when the left front cover is opened). If you must operating the
copier with the left front cover open, you will need to insert the
the left cover
8. The one-way clutch is in operation while the transfer drum is on the transfer drum frame. Do not
rotate the transfer drum while keeping your fingers in an opening of the transfer drum.
The transfer drum, on the other hand, will rotate in reverse when it is off the frame. Keep
this in mind. (Allowing it to rotate in reverse can damage the transfer blade, attraction
brush, and transfer drum side scraper.)
7-48
COPYRIGHT © 2002 CANON INC.
switch. (Do not insert a screwdriver or the like into the laser path.)
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
cover switch
cover switch actuator into