Canon 1130 Service Manual page 796

DENS
Indicates the concentration of developer.
Level 3
DENS-Y computed value (%) of the developer inside the Y
developing assembly
DENS-M computed value (%) of the developer inside the M
developing assembly
DENS-C computed value (%) of the developer inside the C
developing assembly
DENS-K computed value (%) of the developer inside the Bk
developing assembly
WINDOW-Y window soiling correction coefficient for Y
WINDOW-M window soiling correction coefficient for M
WINDOW-C window soiling correction coefficient for C
WINDOW-K window soiling correction coefficient for Bk
DMAX-Y solid density (%) of Y during auto gradation
correction
DMAX-M solid density (%) of M during auto gradation
correction
DMAX-C solid density (%) of C during auto gradation
correction
DMAX-K solid density (%) of Bk during auto gradation
correction
FFRATE-Y correction value of each used to determine the
maximum toner density (FF) while gradation
FFRATE-M
characteristics are being controlled for stabilization
FFRATE-C
FFRATE-K
PTOFST-Y offset value of laser strength for Y patch image
density adjustment
PTOFST-M offset value of laser strength for M patch image
density adjustment
PTOFST-C offset value of laser strength for C patch image
density adjustment
PTOFST-K offset value of laser strength for Bk patch image
density adjustment
COPYRIGHT © 2002 CANON INC.
Description
CANON CLC1100/1130/1150/1160/1180 REV.2 DEC. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 13 TROUBLESHOOTING
COPIER>DISPLAY
Remarks
Indicates to the second
decimal place.
Error if lower than 70%
Compares against the design
value, and omits decimal
places.
Reference: 100
Uses whole numbers,
omitting decimal places
13-211