Editor; Removing The Editor Controller Pcb - Canon 1130 Service Manual

CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
C. Editor
1. Removing the Editor Controller
PCB
1) Remove the six face plates [1] used for
screws.
2) Remove the two screws (M8x6), six
screws (M8x10), and six screws (M8x23),
a total of 14 screws; then, detach the
copyboard cover.
3) Remove the two screws [2], and detach
the controller PCB cover [3].
4) Disconnect the two connectors [4], and
remove the 4 screws [5] and the flat cable
[6]; then, detach the editor controller
PCB[7].
9-24
COPYRIGHT © 2002 CANON INC.
[1]
[2]
[6]
CANON CLC1100/1130/1150/1160/1180 REV.1 JAN. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
Figure 9-715
[3]
Figure 9-716
[5]
[7]
[5]
Figure 9-717
[1]
[2]
[4]
[4]