Canon 1130 Service Manual page 602

Adjusting the Position of the
3
Roll
Make adjustments using the four
mounting screws [4] of the roll support plate
[3] so that the roll [1] is about 3 mm from the
floor [2] when the compartment is fully slid
out.
(At this time, use the graduation [5] on the
front side plate as a reference.)
4 Routing the Lifter Cable
1) Fix the lifter drive shaft and the lifter in
place with a hex wrench [1] and a long
screwdriver [2]
2) Fix the cable fixing plate [3] in place to
the lifter with two screws.
3) Hook the lifter cable on the pulley [4].
4) Hook the ball of the lifter cable on the
pulley [5] of the lifter drive shaft, and
wind the cable along the groove about 1.5
turns. At this time, be sure that the lifter
cable is taut until the long screwdriver
used to keep it in position is lightly lifted.
5) In this condition, secure the pulley in
place to the lifter drive shaft with two set
screws [6].
6) Secure all pulleys to the lifter drive shaft;
then, measure the distance from the base
plate of the compartment to the top
surface of the lifter to make sure that the
lifter is level.
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 13 TROUBLESHOOTING
Figure 13-258
Figure 13-259
13-33