Canon 1130 Service Manual page 544

4) Remove the four screws, and detach the
copier's left lower cover.
5) Open the cable guide, and put the 3-pin
end of the relay harness inside. (If the
guide is difficult to open, use a
screwdriver.)
6) Connect the 2-pin end of the relay harness
to the copier's connector.
If you are installing the
cassette heater to the
CLC1130/1160, make the
following connections:
• relay harness of the
• relay harness of the
COPYRIGHT © 2002 CANON INC.
upper cassette heater
with the lower connector
on the copier side
lower cassette heater
with the upper connector
on the copier side
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 INSTALLATION
Screws
Figure 11-803
Figure 11-804
Relay harness (2-pin)
Relay harness (2-pin)
Figure 11-805
Cable guide
Relay harness
Connector
Connector
11-47