Removing The Internal Static Eliminator; Removing The Separation Changing Assembly; Removing The Polishing Roller - Canon 1130 Service Manual

CHAPTER 7 PICK-UP / FEEDING SYSTEM
7. Removing the Internal Static
Eliminator
1) Remove the transfer drum from the
transfer drum frame.
2) Turn the transfer drum to match the holes
in the plate at the rear of the transfer drum
and the holes in the transfer drum.
3) Remove the claw [1], and pull out the
internal static eliminator [2]
8. Removing the Separation
Changing Assembly
1) Pull out the transfer drum frame.
2) Remove the screw [1], and remove the
separation charging assembly [2].
Be sure to use the initial
screw (binding; M4x6)
when mounting the sepa-
ration charging assembly.
The use of a longer screw
will result in irregular in-
tervals.

9. Removing the Polishing Roller

1) Remove the transfer drum from the
transfer drum frame.
2) Push the transfer roller [1] toward the
front of the transfer drum to remove.
Take care not to touch the
transfer sheet.
7-94
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
Figure 7-855
[2]
Figure 7-856
[1]
Figure 7-857
[2]
[1]