Canon 1130 Service Manual page 218

See to it that the removed
developing assembly will
remain free of foreign
matter.
Do
developing assembly near
the copier and handle the
transfer assembly frame or
the photosensitive drum
frame unit above it.
11) Remove the black toner concentration
sensor unit.
12) Remove the screw [5], and detach the
photosensitive drum positioning roll [6].
13) Remove the three screws [7]; then, loosen
the two fixing pins [8], and slide out the
photosensitive drum frame unit [9].
When sliding out the
photosensitive
frame unit, be sure to work
with extra care so as not to
damage the photosensitive
drum.
If contact is made near the
front, lift it slightly to
remove. At this time,
check to make sure that
the transfer assembly
frame unit is inside the
copier.
COPYRIGHT © 2002 CANON INC.
not place the
drum
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 IMAGE FORMATION SYSTEM
[5]
Figure 6-604
[7] [8]
Figure 6-605
Figure 6-606
[6]
[7] [8] [7]
[9]
6-53