CHAPTER 11 INSTALLATION
8) Remove the shorting connector [8], and
connect the connector [9] (4-pin) of the
control card unit.
(The connector on the copier side is found
under the control panel.)
9) Secure the grounding wire [10] of the
control card to the opening under the
copier's control panel. (The opening is
found to the left of the connector of the
primary charging assembly.)
10) Peel off the protective sheet from the
nameplate of the control card unit.
11) Attach the nameplate [11] of the control
card unit to the copier's control panel.
12) Mount the control panel to the copier.
13) Turn on the copier's power switch, and
check the operation of the control card
unit.
11-32
COPYRIGHT © 2002 CANON INC.
CANON CLC1100/1130/1150/1160/1180 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[8]
[9]
Figure 11-504
[10]
Figure 11-505
[11]
Figure 11-506