Removing The Drum Heater Brush; Pre-Exposure Lamp; Removing The Pre-Exposure Lamp Unit - Canon 1130 Service Manual

CHAPTER 6 IMAGE FORMATION SYSTEM
Do not apply grease or the
like to the slip ring for the
drum heater. In particular,
do NOT use conductive
grease.
If the slip ring friction side
[5] has powder, dry wipe it
lightly to remove.
Do not remove the material
(black) that has caked on
the slip ring friction side. It
serves as lubricant.

6. Removing the Drum Heater Brush

1) Remove the rear cover.
2) Remove the flywheel.
3) Remove the drum motor unit.
4) Remove the screw [1], and disconnect the
two connectors [2]; then, detach the drum
heater brush [3].
Do NOT apply grease to
the drum heater brush.
B. Pre-Exposure Lamp
1. Removing the Pre-Exposure Lamp
Unit
1) Remove the photosensitive drum.
2) Disconnect the connector [1], and remove
the screw [2]; then, detach the pre-
exposure lamp [3].
6-60
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[5]
Figure 6-618
[3] [1]
[2]
[1]
Figure 6-619
[2] [1]
[3]
Figure 6-620