CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
G. Work at the End of a Job
1) On the Job Selection screen, click 'To Unit Selection Screen'.
2) When a dialog box appears asking if you want to end the work, click 'OK' to return to the Unit
Selection screen.
If you have connected to a unit and then decide to connect to a different unit,
be sure to turn off and then on the machine's power switch while the Unit Se-
lection screen remains.
3) End the SST, and shut down Windows.
4) Turn off the machine and the PC.
5) Disconnect the connection cable from the machine and the PC.
6) Shift the machine's mode switch to 'COPY'.
7) Mount the connector cover with a screw, and close the front cover.
8) Turn on the machine, and check the version of the firmware in service mode.
9-2p
COPYRIGHT © 2002 CANON INC.
Figure 9-220
CANON CLC1100/1130/1150/1160/1180 REV.0 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)