Canon 1130 Service Manual page 575

CHAPTER 13 TROUBLESHOOTING
5) Slide out the transfer frame.
6) Place a ruler and
marking (Figure 13-207) etched to the
transfer drum ring (front, rear), and
measure the position d of the
relation to the leading edge of the paper.
Perform this for both sides A and B.
7) Make adjustments so that d is 0 ± 0.5 mm
in service mode (ADJUST>FEED-ADJ).
for side A:ATT-T-A
for side B: ATT-T-B
• Changing ATT-T-A, ATT-T-B to '1'
will shift the point of attraction by
about 0.4 mm.
• A higher setting will delay the start of
attraction (in the direction of the black
arrow) while a lower setting advances
it (in the direction of the white arrow).
8) After adjustment, turn off and then on the
power switch.
• Keep in mind that copies made in
normal mode will be black if you
forget to turn off and then on the
power switch.
13-10
COPYRIGHT © 2002 CANON INC.
paper against the
paper in
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 13-207
(front)
Figure 13-208
(rear)