5) Put the rear positioning shaft (left) [7]
under the gear [8].
6) Put the front positioning shaft [9] through
the large hole to detach the attraction roll
unit.
Do not insert the transfer
drum frame without fitting
the solenoid unit removed
in step 2) back in to avoid
damage. When you have
detached the attraction roll
unit, be sure to mount it
back to its initial position
with its screw.
4. Removing the Scraper of the
Attraction Roller
1) Remove the two TP screws [1], and
detach the toner receptacle [2].
COPYRIGHT © 2002 CANON INC.
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 PICK-UP / FEEDING SYSTEM
Figure 7-814
[9]
Figure 7-815
Figure 7-816
[8]
[7]
[2]
[1]
7-79