Removing The Hopper Motor - Canon 1130 Service Manual

CHAPTER 6 IMAGE FORMATION SYSTEM

3. Removing the Hopper Motor

1) Remove the hopper unit.
2) Remove the screw [1], and detach the
toner receptacle [2].
If the hopper motor does
not rotate or fails to stop, a
transistor on the DC driver
PCB may be damaged. If
such is the case, replace the
DC driver PCB.
3) Remove the two screws [3], and
disconnect the two connectors [4]; then,
remove the connector mount.
4) Remove the two screws [5], and remove
the hopper motor.
6-74
COPYRIGHT © 2002 CANON INC.
[3]
[4]
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2] [1]
Figure 6-656
[4]
Figure 6-657
[5]
Figure 6-658
[3]
[5]